Standard Dock Hardware

Non-Articulating Double Pin Corner Female

Two holes allow for easy attachment and create a non-articulating hinge. The tabs are pre-drilled to accommodate a 3/4" pin or bolt.  This allows for a more rigid connection between dock sections. Weight:  9.50 LBS

Non-Articulating Double Pin Corner Male

Two holes allow for easy attachment and create a non-articulating hinge. The tabs are pre-drilled to accommodate a 3/4" pin or bolt.  This allows for a more rigid connection between dock sections. Weight:  9.25 LBS

Washer Plate

Washer Plates are used with Angles (WD-A) and Cleat Angles (WD-CA). The wood is sandwiched between the steel providing greater strength.  

Single T Male

Has one 3/4" tab and is used with Outside Corner Female (WD-F) or Single T Female (WD-TF) connectors. The tabs are pre-drilled to accommodate a 3/4" pin or bolt.

Single T Female

Has two 1/2" tabs and is used with Outside Corner Male (WD-M) or Single T Male (WD-TM) connectors. Can be bolted to a seawall for hinging ramps or to the side of a dock for finger attachment.

Splice Plate Set

Splice Plates are designed to join two side stringers together to make longer dock sections. The flat plate is used on the outside of the stringer, and the T plate is used on the inside of the stringer. The T plate will attach to the cross stringer as...

Roller Assembly

Ideal for those areas where a sturdy roller assembly is needed.

Ramp Cover Plate Set

The ramp cover plate is designed to cover the gap created by the male/female hardware between the ramp and shore by providing a covered walking surface between the sections. One side is pre-punched and will bolt through the deck surface. The opposite...

Chain Retainer XL Back-up Plate

Backup Plate for Chain Retainer XL, measuring 7.75"" x 7.25"".

Chain Retainer XL

A larger version of the Chain Retainer (WD-CR) that can accommodate up to 1/2"" chain. Measures 5"" tall with 9/16"" slots.  Inside dimensions are 4.25"" x 3"". These are typically bolted to the side of the dock and uses chain to hold the dock in...

Outside Corner Male

Has two 2.5"" tabs and is used with Outside Corner Male (WD-M) or Single T Male (WD-TM) connectors. The tabs are pre-drilled to accommodate a 3/4"" pin or bolt.

Inside Corner Pipe Holder

Can be used to replace a standard inside corner. Has a 3"" I.D. pipe welded into the corner providing internal anchoring. Accommodates 2"" I.D. pipe.