Standard Dock Hardware

Inside Corner

Inside Corners with corner gussets are used as an inside backup for the Outside Corner hardware. The corner gusset provides strength and helps reduce racking.

Pipe holder

Pipe holder, 3"" with backing plate.  Use with 1-1/2"" or 2"" pipe.

Single T Male, Heavy Duty

Has two 3/4" tabs and is used with Heavy Duty Outside Corner Female (WD-HDF) or Heavy Duty Single T Female (WD-HDTF) connectors. The tabs are pre-drilled to accommodate a 3/4" pin or bolt. These are used where additional strength is needed. Uses a...

Single T Female, Heavy Duty

Has three 1/2" tabs and is used with Heavy Duty Outside Corner Male (WD-HDM) or Heavy Duty Single T Male (WD-HDTM) connectors. Can be bolted to the side of a dock for finger attachment. These are used where additional strength is needed. Uses a (WD-HDB)...

Outside Corner Male, Heavy Duty

Has two 3/4" tabs and is used with Heavy Duty Outside Corner Female (WD-HDF) or Heavy Duty Single T Female (WD-HDTR) connectors. The tabs are pre-drilled to accommodate a 3/4" pin or bolt. These are used where additional strength is needed.

Outside Corner Female, Heavy Duty

Has three 1/2" tabs and is used with Heavy Duty Outside Corner Male (WD-HDM) or Heavy Duty Single T Male (WD-HDTM) connectors. The tabs are pre-drilled to accommodate a 3/4" pin or bolt. Use these where additional strength is needed.

Heavy Duty Backup Plates

Has three 1/2"" tabs and is used with Heavy Duty Outside Corner Male (WD-HDM) or Heavy Duty Single T Male (WD-HDTM) connectors. The tabs are pre-drilled to accommodate a 3/4"" pin or bolt. Use these where additional strength is needed.  

Finger Pipe Stabilizer

Our pipe type finger dock stabilizer is an easy way to stabilize your finger dock. We use two WD-TF Single T Females, two WD-B Backup Plates, and 1.5"" galvanized pipe. A 3/4"" Bolt and Nylon Lock Washer connect each end (included).

Finger Deck Stabilizer 45

Using our WD-FDS45 and WD-FDS135, you can construct a finger deck stabilizer. This assembly helps stabilize narrow fingers by spreading the load onto the main dock. The WD-B Backup Plates are used as backups to the T (not included).

Finger Deck Stabilizer 135

Using our WD-FDS45 and WD-FDS135, you can construct a finger deck stabilizer. This assembly helps stabilize narrow fingers by spreading the load onto the main dock. The WD-B Backup Plates are used as backups to the T (not included).

Outside Corner Female

Has one 1.75"" tab and is used with Outside Corner Female (WD-F) or Single T Female (WD-TF) connectors. The tabs are pre-drilled to accommodate a 3/4"" pin or bolt.  

Outside Corner End

Outside Corner Ends are used at the end of docks, ends of finger docks, swim floats corners, or when plain ends are needed.