American Muscle Docks

1/2"x 3" HDG Carriage Bolt Set""

Our Residential Wood Dock Hardware uses 3/8"" HDG Carriage Bolts. Comes with bolt, flat washer, and nut. This size: 3/8"" x 3""  Other bolt sizes available. American Muscle Docks Residential...

3/4"x 4 HDG Connector Pin & Hitch Clip""

3/4""x 4 HDG Connector Pin & Hitch Clip

3/4"x 6 HDG Connector Pin & Hitch Clip""

Rubrail, Flat, 4.7 inches wide by 10 feet long, available in black or white

Angle

Used for attaching cross stringers to side stringers. Two Washer Plates (WD-W) are used with each Angle to sandwich lumber and provide a solid connection.

Back-up Plate

Heavy Duty Backup Plates are used to backup the (WD-HDTM) Single T Male and (WD-HDTF) Single T Female connectors. 5"" x 5"" x 1/4"" Backup Plates are used to backup Single T Female (WD-TF) and Single...

Chain Retainer

These are typically bolted to the side of the dock or to a cross stringer and can accommodate up to 1/2"" chain to hold the dock in place. Use a WD-B as a backup plate. There is also an XL Chain...

Chain Retainer XL

A larger version of the Chain Retainer (WD-CR) that can accommodate up to 1/2"" chain. Measures 5"" tall with 9/16"" slots.  Inside dimensions are 4.25"" x 3"". These are typically bolted to the...

Chain Retainer XL Back-up Plate

Backup Plate for Chain Retainer XL, measuring 7.75"" x 7.25"".

Cleat Angle

The Cleat Angle is bolted to the inside of the side stringer and uses a WD-W washer plate as a back up. The cleat is bolted through the deck and through the cleat angle. The slotted holes allow for...

Cleat Angle XL

The XL Cleat Angle is for cleats larger than 12"". The Cleat Angle is bolted to the inside of the side stringer and uses a WD-W washer plate as a back up. The cleat is bolted through the deck and...

Cleat Flat Washer

The Cleat Flat Washer provides additional holding strength in areas a cleat angle cannot be used.

Corner Bumper, 10x10

Corner Bumper, 10"x10", Available in Black or White