American Muscle Docks

Outside Corner End

Outside Corner Ends are used at the end of docks, ends of finger docks, swim floats corners, or when plain ends are needed.  

Outside Corner Female

Has one 1.75"" tab and is used with Outside Corner Female (WD-F) or Single T Female (WD-TF) connectors. The tabs are pre-drilled to accommodate a 3/4"" pin or bolt.  

Outside Corner Female, Heavy Duty

Has three 1/2" tabs and is used with Heavy Duty Outside Corner Male (WD-HDM) or Heavy Duty Single T Male (WD-HDTM) connectors. The tabs are pre-drilled to accommodate a 3/4" pin or bolt. Use these...

Outside Corner Male

Has two 2.5"" tabs and is used with Outside Corner Male (WD-M) or Single T Male (WD-TM) connectors. The tabs are pre-drilled to accommodate a 3/4"" pin or bolt.

Outside Corner Male, Heavy Duty

Has two 3/4" tabs and is used with Heavy Duty Outside Corner Female (WD-HDF) or Heavy Duty Single T Female (WD-HDTR) connectors. The tabs are pre-drilled to accommodate a 3/4" pin or bolt. These are...

Pipe holder

Pipe holder, 3"" with backing plate.  Use with 1-1/2"" or 2"" pipe.

Ramp Cover Plate Set

The ramp cover plate is designed to cover the gap created by the male/female hardware between the ramp and shore by providing a covered walking surface between the sections. One side is pre-punched...

Ramp Roller Kit

Building a roller ramp has never been easier using our ramp roller kits. The outside roller brackets are backed up with our standard WD-E Outside Corner Ends and the center roller bracket is backed...

Roller Assembly

Ideal for those areas where a sturdy roller assembly is needed.

Single T Female

Has two 1/2" tabs and is used with Outside Corner Male (WD-M) or Single T Male (WD-TM) connectors. Can be bolted to a seawall for hinging ramps or to the side of a dock for finger attachment.

Single T Female, Heavy Duty

Has three 1/2" tabs and is used with Heavy Duty Outside Corner Male (WD-HDM) or Heavy Duty Single T Male (WD-HDTM) connectors. Can be bolted to the side of a dock for finger attachment. These are...

Single T Male

Has one 3/4" tab and is used with Outside Corner Female (WD-F) or Single T Female (WD-TF) connectors. The tabs are pre-drilled to accommodate a 3/4" pin or bolt.